Tuesday, September 25, 2007

CCTV Security Review

CCTV Tools.















The BNC connector is used for RF signal (typically pro-video connections, both for analogSerial Digital Interface video signals, amateur radio antenna connections, aviation electronics (avionics) and on nearly every piece of electronic test equipment manufactured in the last 35 or so years. This connector is an alternative to the RCA connector when used for composite video on commercial video devices, however many consumer electronics with RCA jacks can be used with BNC-only commercial video equipment via a simple adaptor. BNC connectors were commonly used on 10base2 thin Ethernet networks, both on cable interconnections and network cards, though these have largely been replaced by newer Ethernet devices whose wiring does not use coaxial cable. Some networks use BNC terminated coax.

Another Definition of BNC Connector.

Short for Bayonet Neill Concelman connector, (sometimes erroneously called a British Naval Connector or Bayonet Nut Connector,a type of connector used with coaxial cables such as the RG-58 A/U cable used with the 10Base-2 Ethernet system. The basic BNC connector is a male type mounted at each end of a cable. This connector has a center pin connected to the center cable conductor and a metal tube connected to the outer cable shield. A rotating ring outside the tube locks the cable to any female connector.

BNC connectors can also be used to connect some monitors, which increases the accuracy of the signals sent from the video adapter.

No comments:

Post a Comment